Exchange 2010 - 2 DAG members in 1 site / Witness Server and 1 node failure
Ok, Xiu.But I think that command needs cluster service started.I will try it and tell you.ThanksCristian L Ruiz
View ArticleExchange 2010 - 2 DAG members in 1 site / Witness Server and 1 node failure
Hi,Yes, you can try to use Set-DatabaseAvailabilityGroup to provision the new FSW and witness directory and then move the Cluster Group from NodeA to NodeB.Xiu ZhangTechNet Community Support
View ArticleExchange 2010 - 2 DAG members in 1 site / Witness Server and 1 node failure
where is the microsoft article where say that is supported? please I will be very pleased to have an official paper saying that is supported.ThanksCristian L Ruiz
View ArticleExchange 2010 - 2 DAG members in 1 site / Witness Server and 1 node failure
it will work within the site, don't worry it is supported
View ArticleExchange 2010 - 2 DAG members in 1 site / Witness Server and 1 node failure
Hi!, thanks for your early reply.But that method talks about having 2 DAG members in different sites, as I read in this procedure never said that can be use it in just 1 site. So is intended to be used...
View ArticleExchange 2010 - 2 DAG members in 1 site / Witness Server and 1 node failure
Hi!, thanks for your early reply.But that method talks about having 2 DAG members in different sites, as I read in this procedure never said that can be use it in just 1 site. So is intended to be used...
View ArticleExchange 2010 - 2 DAG members in 1 site / Witness Server and 1 node failure
Hi,If you haven't enabled the DAC mode you should be able to start the cluster using the /forcequorum switchhttp://technet.microsoft.com/en-us/library/dd351049.aspxLeif
View ArticleExchange 2010 - 2 DAG members in 1 site / Witness Server and 1 node failure
you can use hte forcquorum method along with the alternate FSW:http://blogs.msexchange.org/walther/2010/02/14/two-member-dag-in-a-multi-site-scenario-supported/ Regards, Mahmoud Magdy Watch Arabic...
View ArticleExchange 2010 - 2 DAG members in 1 site / Witness Server and 1 node failure
Hi,I have a 2 DAG members in only 1 site using Exchange 2010.I know that if Witness Server and 1 node fail in a 2 DAG members configuration (for example because of a power outage) the cluster solution...
View Article